Skip to main content
Hsdian Construction Machinery - North America

Home / Replacement Of Sand By Marble Powder In Concrete

Replacement Of Sand By Marble Powder In Concrete

Hot Products

Partial replacement of sand with marble waste and scoria ...

In this research work, the effects of using waste marble powder (WMP) as a partial replacement of cement and sand on the properties of the concrete have been investigated. The compressive strength ...

Read More

Use of Waste Marble Powder as Partial Replacement in ...

It can be observed that the flexure strength for the concrete mix containing 10% of marble powder dust in cement got increased by the value of 9.2% and for 10% replacement with sand the flexure strength also got increased about 9.3% but it decreased when the mix contains 20% marble powder dust against cement (10%) and sand(10%) about 10%.

Read More

Use of Waste Marble Powder as Partial Replacement in ...

marble dust powder on the concrete mix by partially replacing cement and sand with the marble powder dust. In this project, we check the effect on mechanical and physical properties of a concrete mix if varying marble powder dust is partially replaced in the concrete mix. 1.1 Research Significance

Read More

Partial Replacement of Cement With Marble Powder in Concrete

Marble powder: The marble dust is obtained from RAK ceramics. The specific gravity of tile dust is found to be 2.62 and the fineness is found to be 7.5%. 3.METHODOLOGY: The evaluation of tile powder which is used as a replacement of cement material begins with the concrete testing.

Read More

Experimental Study On Concrete Using Waste Marble powder ...

of using marble powder waste as partial replacement of fine aggregate in concrete. Since this concrete is prepared with marble powder as a partial replacement of fine aggregate (Sand) in four different proportions i.e. 10%, 15 % ,20% and 25 % and tested for the period of

Read More

A study of the chemical effect of marble and granite ...

Feb 04, 2020 · For sand replacement, and by replacing 10% of sand with marble powder in (NF10), the compressive strength value rises up to 5% above the control CM. Replacing 5% of cement and 10% of sand with marble waste powder in NC5 + NF10 mix gives almost the same compressive strength value obtained from CM.

Read More

An Experimental investigation on utilizations of Marble ...

The durability as well as workability has increased to large extent by use of marble dust as replacement of fine aggregate and coarse aggregate. The effect on properties of concrete were investigated and concluded that optimum percentage for replacement of sand with marble powder in concrete

Read More

"Partial Replacement of Cement with Marble Dust Powder"

Waste Marble Utilization from Residue Marble Industry as a Substitution of Cement and Sand within Concrete Rooftile Production ... 12.3 % . Replacement PC with marble powder by 20 % qualify ...

Read More

Properties of concrete incorporating sand and cement with ...

marble powder as a partial replacement in the cement and sand mix, where MX0 is control mix with no marble powder, MX1 with 10% marble powder as partial replacement of sand, MX2 with 10% marble powder as partial replacement of cement and MX3 with 15% marble powder as partial

Read More

Partial replacement of sand with marble waste and scoria ...

In this research work, the effects of using waste marble powder (WMP) as a partial replacement of cement and sand on the properties of the concrete have been investigated. The compressive strength ...

Read More

Partial Replacement of Cement with Marble Dust Powder

Experimental Study on Partial replacement of Sand with Marble Dust Powder in high strength concrete Deepankar Kumar Ashish , K. Verma , R. Kumar , Nitisha Sharma , G. Pathan 2018

Read More

Partial replacement of sand with marble waste and scoria ...

Nov 02, 2020 · Sand is used more than any other natural resources except water and air, However, it’s extracted at a rate far greater than it’s renewal. The availability of sand in the growing demand of the construction industry will be a challenge due to a wide range of variability, cost, and, quality problems. This study aims to investigate normal strength concrete by partially replacing sand with ...

Read More

UTILIZATION OF WASTE QUARRY DUST AND MARBLE

incorporating marble powder as partial sand substitute. Corinaldesi et al. (2010), found that at same workability, marble powder showed high strength at 10% sand substitution. This research aims at utilization of waste marble powder and quarry dust in concrete as partial replacement of sand.

Read More

Experimental Study On Concrete Using Waste Marble powder ...

of using marble powder waste as partial replacement of fine aggregate in concrete. Since this concrete is prepared with marble powder as a partial replacement of fine aggregate (Sand) in four different proportions i.e. 10%, 15 % ,20% and 25 % and tested for the period of

Read More

Properties of concrete incorporating sand and cement with ...

marble powder as a partial replacement in the cement and sand mix, where MX0 is control mix with no marble powder, MX1 with 10% marble powder as partial replacement of sand, MX2 with 10% marble powder as partial replacement of cement and MX3 with 15% marble powder as partial

Read More

"Partial Replacement of Cement with Marble Dust Powder"

Waste Marble Utilization from Residue Marble Industry as a Substitution of Cement and Sand within Concrete Rooftile Production ... 12.3 % . Replacement PC with marble powder by 20 % qualify ...

Read More

(PDF) Partial Replacement of Cement to Concrete by Marble ...

LITRATURE REVIEW 1 Valeria (2005):He observed that marble dust OBJECTIVES powder had very high Balinen fineness value of To study the influence of partial about 1.5m2/g, with 90% of particles passing replacement of cement to concrete with through 50 micron sieve and 50% through marble dust powder, and to determine the 7micron sieve.

Read More

Properties of concrete incorporating sand and cement with ...

marble powder as a partial replacement in the cement and sand mix, where MX0 is control mix with no marble powder, MX1 with 10% marble powder as partial replacement of sand, MX2 with 10% marble powder as partial replacement of cement and MX3 with 15% marble powder as partial

Read More

Influence of limestone waste as partial replacement ...

Influence of limestone waste as partial replacement material for sand and marble powder in concrete properties Omar M. Omar a, Ghada D. Abd Elhameed b,*, Mohamed A. Sherif a, Hassan A. Mohamadien c a Department of Civil Construction and Architecture, Faculty of Industrial Education, Suez, Egypt b Building Materials Research and Quality Control Institute, Housing and Building National Research ...

Read More

UTILIZATION OF WASTE QUARRY DUST AND MARBLE

incorporating marble powder as partial sand substitute. Corinaldesi et al. (2010), found that at same workability, marble powder showed high strength at 10% sand substitution. This research aims at utilization of waste marble powder and quarry dust in concrete as partial replacement of sand.

Read More

project on partial replacement of sand with marble powder ...

Use of Waste Marble Powder as Partial Replacement in It can be observed that the flexure strength for the concrete mix containing 10 of marble powder dust in cement got increased by the value of 92 and for 10 replacement with sand the flexure strength also got increased about 93 but it decreased when the mix contains 20 marble powder dust ...

Read More

Scope of Utilization of Waste Marble Powder in Concrete as ...

marble powder and partial replacement of marble waste powder with sand and cement at 10% and 15% respectively. Properties tested includes, workability and split tensile strength. By slump cone test it was found that the replacement of marble powder with cement and sand has no effect on workability. It was observed that slump decreases

Read More

An Experimental investigation on strengths characteristics ...

characteristics of concrete using as a partial replacement of cement by marble dust powder and sand by stone dust. The Dissertation work is carried out with M 30 grade concrete for which the marble powder is replaced by 0%, 5%, 10%, 15%, 20% by weight of cement. For all the mixes compressive,

Read More

Effects of Partial Replacement of Cement with Marble Dust ...

the percentage of marble dust powder for up to 10% partial replacement of cement with marble dust powder. With further increase in the percentage of marble dust powder the split tensile strength of concrete decreases. The split tensile strength of

Read More

partial replacement of cement with marble powder gekko ...

Partial Replacement of Cement With Marble Powder in Concrete. Partial replacement of marble powder in cement accordingly in the range of 20%, 30%, 40%, by weight for M20 grade of concrete. With this experimental research work the problem of waste production management of this agro waste are will be solved. More

Read More

partial replacement of cement with marble powder

Evaluation Of Concrete With Partial Replacement Of. This study aims to evaluate concrete having waste marble powder wmp as partial replacement of cement marble is the metamorphic form of limestone caco 3 and wmp was chosen as substitute of cement on account of its high calcium oxide content wmp is byproduct of marble industry and is an environmental burden

Read More

sand replacement by crusher and marble powder philippines

Light weight concrete with partial sand with wooden powder. May 01 2017 0183 32 August 2013 Chandana Sukesh Katakam Bala Krishna PSri Lakshmi Sai Teja SKanakambara Rao Partial Replacement of Sand with Quarry Dust in Concrete May 2013 MsMonica C Dhoka Green Concrete Using Industrial Waste of Marble Powder Quarry Dust and Paper Pulp October 2013 MVRama Raju

Read More

INFLUENCE OF SILICA FUME, MARBLE POWDER, GRANITE

based upon cement or sand replacement by the marble powder. Results obtained that 10% substitution of sand by the marble powder provided maximum compressive strength at about the same workability. Moreover, an even more positive effect of marble powder

Read More

Effect of using Marble Powder in Concrete Mixes on the ...

In recent years Marble is considered one of the most important decorative building materials. Marble powder is one of the materials which severalty affects the environment and health problems. It is produced from sawing, shaping, and polishing process. This research aims to study the effect of using marble powder as partially replace of cement on the properties of concrete.

Read More

PARTIAL REPLACEMENT OF CEMENT WITH MARBLE DUST

replacement of Cement with Waste Marble Powder Partial replacement of cement by varying percentage of marble powder reveals that increased waste marble powder (WMP) ratio result in increased strengths of the mortar and concrete Thus they found out the optimum percentage for replacement of MDP with cement and it is almost 12.5

Read More

USE OF MARBLE POWDER AS A PARTIAL REPLACEMENT OF

strength as about 26.6Mpa. The result of 5 and 10 percentage replacement of marble powder is accepted. We also found that the there is sudden increase in the strength of concrete as the percentage of marble powder increases above the 10% and after replacement of 20% of marble powder there is reduction in strength.

Read More